External Analog

How to wire and configure a Neptronic HRO20 humidity controller with a SKE4 humidifier

External Network

How to configure a SKE4 humidifier to the network control modes for communication via BACnet or Modbus

Internal Analog

How to configure the SKE4 humidifier as an internal setpoint control using a remote transmitter

Klixon Thermal Cutout

This video describes the operation of the thermal cutout swtich for the SKE4 humidifier, as well as its associated alarm

Automatic Fill Valve

This video describes the opreration of the 3-way valve used to fill the water in the evaporation chamber and cool down the drain for the SKE4 humidifier

Solid-State Relay

This video describes the operation of the solid-state relay and the SCR control

Drain Cycles

How to set the frequency of drain cycle on the SKE4 humidifier

Blowdown Rate

How to configure the blowdown rate or water dilute setting on a SKE4 humidifier

Lowering Steam Output

How to limite the steam capacity of a SKE4 modulating humidifier

Service and Operating Hours

This video is about viewing the number of operating hours and the number of hours of the last servicing on a SKE4 humidifier as well as how to configure the service intervals

Resetting Service Hours

How to reset the service counter after perfoming maintenance of the SKE4 humidifier

Maintenance Procedure

In this video, you will see how to perform maintenance and clean the evaporation chamber on a SKE4 humidifier

Failed Pump

What to do if the FailedPump alarm appears on the SKE4 humidifier

Contactor Fuse

What to do if the ContactorsFuse alarm appears on the SKE4 humidifier

Fill Timeout

What to do if the FillTimeout alarm appears on the SKE4 humidifier

Heat Timeout

What to do if the HeatTimeout alarm appears on the SKE4 humidifier

Overheat

What to do if the Overheat alarm appears on the SKE4 humidifier

Water Temperature

What to do if the WaterTemp alarm appears on the SKE4 humidifier